Control Gear Tray: The white epoxy powder coated gear tray carries the control gear and lampholders, and also is designed to act as a reflector.
Two nylon cords allow the gear tray to be suspended from the body during installation and service.

Body: The single piece deep drawn body may not be drilled on site.

Clip: Double acting. Stainless steel clips.

Lens: 4 mm thick clear tempered plate glass.

Gasket: Extruded silicone one piece gasket.

Lens Frame: Pressed from a single piece sheet without joining welds and with extra wide ends for increased rigididity.

Frame Suspension: The lens frame is suspended from two points along one side from the body to allow the glass frame to swing open during lamp change and servicing.

Control Gear: Semi-electronic, electronic or switch start each designed for low temperature rise in Zone 2 applications.
The special electronic starters have a safety cut out feature, this prevents lamp flicker and extends lamp life.

Cable Entry: Threaded Entry M20x1,5 provided for a gland, via a special boss welded in for positive sealing. Corrosion resistant glands are recommended for use with stainless steel light fittings. Any change of gland on site invalidates the Certification. Terminal Connection 4mm².

Entries: Single entry standard, twin entry a special order.

Emergency mode: Special solid state inverter/chargers for Zone 2 applications available in 36 Watt version only.

Fixing: M8 nut welded into the rear mounting brackets, allow for either a bracket, or pole clamps. The fitting is supplied with Eye bolts for an easy, suspended installation.

Sizes of N50 luminaires: Twin and Single
Stainless Steel Grade : 304; Marine Grade : 316 on special order only.

Complies with SABS 969 or SABS 970