The 4 mm thick lens is clear armour plate glass which is sealed into the frame with a silicon gasket.

The luminaire is provided with 2 blind M8 mounting brackets so no drilling of the body is necessary this ensures the IP 65 (IP66 on request) rating is maintained.

Available in single and twin lamp 18, 36 and 58 Watt versions as well as our new 20x3W and 40x3W LED’s equipped with LUXEON® Rebel high-power LED offering industry leading flux density, and elevated standards for light output.

Special application: Luminaires with 150Watt HID high pressure sodium or metal halide lamps are also available.

Control Gear Tray:
The white epoxy powder coated gear tray carries the control gear and lamp holders, and is also designed to act as a reflector. LED units are equipped with special optics. Two nylon cords allow the gear tray to be suspended from the body during installation and service.

Body:
The single piece deep drawn body may not be drilled on site.

Clip:
Double acting. stainless steel clips.

Lens:
4 mm thick clear tempered plate glass.

Gasket:



Lens Frame:
Pressed from a single piece stainless steel sheet without joining welds and with extra wide ends for increased rigidity

Frame Suspension:
The lens frame is suspended from two points to allow the glass frame to swing open during lamp change and servicing.

Control Gear:
Electronic AC or DC, or switch start each designed for low temperature rise.

Cable entry:
20 mm gland entry provided by a special threaded boss welded in for more positive sealing. Corrosion resistant shrouded glands are recommended for use with stainless steel light fittings.

Entries:
Single entry standard, twin entry a special order.

Emergency mode:
Inverter/chargers and nickel cadmium rechargeable cells can be fitted to operate in the maintained mode.

Fixing:
8 mm threaded nut welded into the rear mounting brackets, allow for either brackets, suspension hooks, pole clamps or anti vibration mountings. The fitting is supplied with Eye bolts.

Material Grade:
Stainless 304.