Control Gear Tray: The white epoxy powder coated gear tray carries the control gear and
lampholders, and is also designed to act as a reflector.
Two nylon cords allow the gear tray to be suspended from the body during
installation and service.
Body: The single piece deep drawn body may not be drilled on site.
Clip: Double acting. Stainless steel clips.
Lens: 4 mm thick clear tempered plate glass.
Gasket: Extruded silicone one piece gasket.
Lens Frame: Pressed from a single piece sheet without joining welds and with extra wide ends
for increased rigidity.
Frame Suspension: The lens frame is suspended from two points along one side of the body to allow
the glass frame to swing open during lamp change and servicing.
Control Gear: Semi-electronic, electronic AC or DC, or switch start each designed for low
temperature rise.
Electronic Starters: Special electronic starters prevent lamp flicker and extend lamp life and give
reliable starting to -40°C, and have a safety cut out feature at the end of lamp life.
Can replace a normal glow starter. Require switching after lamp change.
Cable entry: Threaded Entry M20 x 1,5 is provided for a gland, which is welded in for
more positive sealing. Corrosion resistant glands are recommended for use with
stainless steel light fittings.
Entries: Single entry standard, twin entry a special order.
Emergency mode: Inverter/chargers and nickel cadmium rechargeable cells can be fitted to operate
in the maintained mode.
Fixing: M8 threaded nut welded into the rear mounting brackets, allows for either a
bracket, suspension hooks or pole clamps. The fitting is supplied with Eye bolts.
Stainless Steel Grade: Stainless 304.
|
